1. Toyota 4Runner
  2. Problems
  3. 2007
  4. Service Brakes

2007 Toyota 4Runner Service Brakes Problems

17
Owner complaint records in our dataset

Records are owner complaints, not a measured failure rate.

Owner complaint recordsComplaint records reflect reports in our dataset and do not measure how frequently the problem occurs across all vehicles.

Among these 17 stored complaint records:

  • 1 indicate a crash
  • 0 indicate injury
  • 0 indicate fire

What owners report

  • brake pedal · 5 records

Mileage in stored records

BandRecords
100–150k mi7
60–100k mi5
30–60k mi1

Complaint records

Owner-submitted complaint content, presented as stored.

  • April 24, 2019 · 111,000 miles

    Electrical System · Service Brakes

    Tl* the contact owns a 2007 toyota 4runner. After starting the vehicle, a high pitched audible alarm sounded and the abs, traction control, and emergency brake sensors remained illuminated. Also, when depressing the brake pedal to stop the vehicle, the brakes malfunctioned and the pedal traveled to the floorboard. The vehicle was towed to jim hudson toyota ([redacted], irmo,sc) , but the cause of the failure could…

    ODI 11203657

  • September 6, 2018 · 85,000 miles

    Body · Service Brakes · Suspension

    Vehicle frame is extremely corroded to the point where replacing necessary items such as shocks/struts/steering components is not possible without irreparable damage. Factory welds at critical points of the frame structure are starting to fail and causing safety concerns. This vehicle is regularly garaged and only has 85,000 miles. This is unacceptable, there have been previous recalls and for other models that…

    ODI 11129200

  • November 18, 2017 · 126,000 miles

    Service Brakes

    When i am driving on a bumpy unlevel street and stepping on the brake paddle to slow down the brakes give out and then catch again, i find this to be very dangerous and might even cause an accident especially if there is another car to my front, this has happened to me quite a few times. The brake system has to be checked on a bumpy paved road, brakes will catch and release and catch and release. This happens every…

    ODI 11103735

  • October 17, 2017

    Service Brakes

    Complete and permanent damage of abs and brake module ian's results in no brakes while running the car.

    ODI 11100666

  • April 13, 2017 · 113,835 miles

    Service Brakes · Vehicle Speed Control

    I am requesting that dot nhtsa investigate the driver's contribution to unintended acceleration (ua) and toyota's accelerator/brake pedal designs that make it possible. I was driving my toyota 4 runner in the neighborhood street of my community. My speed was less than 30mph and it accelerated suddenly. I applied the brake and instead of slowing down the vehicle began to gain speed. I pressed harder on the brake and…

    ODI 11092054

  • January 1, 2017

    Service Brakes

    Actuator/accumulator/mastercylinder squeak/squeal

    ODI 10953976

  • July 13, 2015 · 128,000 miles

    Service Brakes

    The braking system vibrates and squeals when driving and braking... Told the abs/master cylinder system needs to be replaced at the cost of $3082.25. Started noticing problems at about 128000 miles on vehicle. Doesn't seem right that there is a major malfunction/repair needed with such low mileage

    ODI 10733746

  • June 3, 2015 · 109,300 miles

    Service Brakes

    The dashboard alarm sounded and the abs, vsc, brake, and traction control warning lights illuminated. This was followed by complete brake failure. Fully depressing the brake pedal would not stop the vehicle. Dealer diagnosed a failed master cylinder assembly.

    ODI 10724018

  • October 30, 2014 · 74,650 miles

    Service Brakes · Wheels

    Vehicle purchased used july 2011 w/ 45k miles. In may 2012 at 55k had brakes repaired, all 4 wheels new rotors pads and hardware. In 2014 noticed brake fluid leaking from caliper and discoloring wheels. Dealer service verified front calipers frozen (guide pins and pads rusted in place as well as caliper pistons). This appears to be a design flaw as the caliper does not incorporate any protective boot for the guide…

    ODI 10653101

  • August 11, 2014 · 96,000 miles

    Service Brakes

    While driving with my entire family on i-95, the vehicle abs assembly began cycling repeatedly. When depressing the brakes while the abs was cycling, the brake pedal would grind and slippage occurred in the pedal pressure. No warning lights. *tr

    ODI 10629970

  • July 29, 2014

    Equipment Adaptive/Mobility · Service Brakes · Vehicle Speed Control

    Over the past 9-12 months i have owned the 4runner, i have noticed the floormats slide up behind the brake and acceleration pedal when i am constantly switching between the two (eg. Heavy traffic, long trips, etc.). I usually am able to pull them back down at a stoplight or stop sign; however, on tuesday, july 29th, i was involved in an auto accident that was not only in heavy traffic, but while on a 200+ mile trip…

    Crash reported

    ODI 10618016

  • August 3, 2013 · 102,000 miles

    Service Brakes

    Tl* the contact owns a 2007 toyota 4runner. The contact stated that while driving approximately 30 mph, the brake pedal was depressed and abnormally traveled to the floorboard. The contact mentioned that the emergency brake was used in order to stop the vehicle. The vehicle was taken to a dealer where it was diagnosed that the master cylinder abs ecu assembly needed to be replaced. The manufacturer was notified of…

    ODI 10536578

  • July 21, 2013

    Service Brakes

    Machines break but when parts represent a risk of fatality, they should be more closely scrutinized. I got lucky when the brake booster assembly went out in my 2007 toyota 4runner while it was parked and running in my garage for 5 minutes while i unloaded it. Had i not made the decision to let the car run while i unloaded it, a decision that i first questioned, it more than likely would've gone out the following…

    ODI 10532984

  • November 20, 2012 · 59,000 miles

    Service Brakes

    I come to a stop and my vehicle pulls, like somebody hit my vehicle from behind. Its constant , it happens all the time. I did take it to a dealer and they said there was nothing that could be done, they advised toyota had not come out with a recall yet for that problem. They advised it was a common problem with the drivetrain . I really do not want this vehicle any more if it is always going to do this.. What makes…

    ODI 10485461

  • August 11, 2012 · 103,000 miles

    Service Brakes

    Tl* the contact owns a 2007 toyota 4runner. The contact stated that while driving 5 mph and applying the brakes, the brakes abnormally traveled to the floorboard. The abs system warning light then illuminated. The vehicle was towed to the dealer who replaced the hydro-booster braking system. The manufacturer was notified who advised that there were no recalls and he should file a complaint. They offered no further…

    ODI 10472907

  • May 29, 2012 · 63,000 miles

    Service Brakes

    Tl* the contact owns a 2007 toyota 4runner. The contact stated that while driving 30 mph, she noticed that her vehicle would not stop once the brakes were applied. She had to utilize the emergency brake and was able to stop the vehicle. The vehicle was not taken to the dealer for inspection or repair. The manufacturer was contacted and stated that the vehicle was no longer under warranty. The vehicle was not…

    ODI 10460193

  • September 1, 2011 · 100,000 miles

    Body · Engine · Service Brakes

    The whole area of exposed steel has been so corroded with rust that i acnnot even remove bolts to service several of the key components in the engine compartment. The frame, cross members, suspension etc. Are also affected in this way.i'm no expert but it is progressively becoming more and more unsafe to drive especially if i lose brakes or some other necessary function. Please help, is this a bad batch of cheap…

    ODI 11129441

Catalog parts for this system

Catalog year/make/model rows for 2007 Toyota 4Runner.

Catalog fitment does not by itself prove OEM-equivalent compatibility.