Problems with 2005 Toyota 4Runner STEERING

Extensive body frame rust.large rusted out holes in frame. unable to get ma. vehicle yearly inspection sticker. emissions test failed (ma. inspection station #pb004755). vehicle bought new 6/2005 recommended not to drive vehicle due to extensive holes in frame.

Severe frame and front end rust, vehicle well taken care of> should have been part of tacoma recall!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

Frame rusted leading to failure of sway bar brackets causing steering to become unstable. this occurred while driving straight down a highway. the repair estimate is total frame replacement.

Steering column rusted through. hard to turn, when turning wheel it goes from smooth(normal) then grabby. i almost flipped my vehicle when turning off of mass avenue in somerville. if i was driving any fast i would have rolled. i don't know if any wheels came off the ground, but it was close.

Brought vehicle to repair shop for muffler and tailpipe inspection. repair shop found frame cracked and rusted along with steering shaft broken. repair shop indicated that there is no recall on 4runners yet this is a known problem with the 2005 4runner. repair shop stated it would cost $6000.00 for new frame from toyota dealer. hartford toyota superstore has done oil changes on this vehicle since purchase yet has never brought the frame problem to our attention.

This vehicle has a very rusty frame. it does not pass state of maine inspection. like many other 4runners it suffers from toyota's faulty frames. this truck has not fallen apart and crashed like many similar units. this one has a perforated frame, and doesn't pass inspection. with 80,000 miles the truck is like new except for the faulty frame. the rust multiplies sitting still or traveling. the frame is so thin in so many places, there isn't place to make satisfactory repairs.

Severe frame rust to the point of holes. the frame integrity will soon be compromised; if not already. two rear body mounts are rusting away, the bottom of both mounts is non existent. one mid mount, the sheet metal side is nearly rusted through. one front mount area is rusted away on the sheet metal side. the gas tank is currently only held in place by what is left of the protection shield under the tank .

Last september, i sent a written plea asking toyota to evaluate and correct the excessive frame corrosion on my 2005 4runner. the vehicle has never been registered outside south carolina or ever been exposed to road salt. toyota's response disclaiming responsibility was unsatisfactory. toyota is well aware of this problem and has corrected this identical problem on similar models and model years. yesterday, my wife and i and two friends riding with us narrowly escaped a fatal accident when the front suspension separated from the frame due to the corrosion problem. at highway speed, the vehicle began shaking violently and the steering was unable to properly control the vehicle. the vehicle went off the road after coming close to hitting an oncoming vehicle. it was towed to an experienced independent mechanic who expressed disbelief at the corroded condition of the frame and immediately declared the vehicle unrepairable and inoperable. he said we were fortunate to have survived the structural failure. in light of the fact that toyota is aware of severe corrosion on similar vehicles and has corrected the issue on some models, please investigate this and determine ...

My suv only has 66,000 miles on it and recently (past month) the steering is very laborious. to the point that i have neck and shoulder pain. the steering is hard to start a turn (no matter what speed) and as i continue to turn the wheel it will ease up a bit and then be hard to turn it back again to straight. meaning that it will not return without considerable effort. i was on cars.com website as they had recalls listed. i looked up 4 runner steering problems and they gave me a recall number. when i called toyota they told me there were no recalls for my vin #. i think toyota is ripping me off because the problem i'm having is just what is described in the summary. the component listed is steering; linkages; rod; relay; connecting. the consequence listed is if the vehicle is continued to be operated in this condition, the relay rod may fracture, increasing the risk of a crash. the recall number is 05v389000 and the recall date is 09-06-2005. plus my wife and i do not turn the wheel until the vehicle is moving. we are old enough to know what ...

The steering system of the car is not behaving properly. it is much harder to turn than normal. furthermore, when driven through curve, the steering does not align back to a straight line as it has done in the past. so, in other words if you drive through a curve and let the steering wheel go free, the car will not straighten out but continue to follow the curve. the steering has to be pulled hard to straighten the vehicle out and drive a straight line. no warning lights are coming up in the instrument cluster to advise of any malfunction. *tr

Vibration issues.sterring whell vibrates even after with a set of 4 knew tires.at speed of about 5o milles / hour vibration starts.

Tl* the contact owns a 2005 toyota 4 runner. while driving 70 mph, the vehicle became difficult to steer. the steering was very tight traveling around curves. the steering failed without warning. the vehicle was taken to an independent mechanic where it was diagnosed that the steering column u joint was severely corroded. the manufacturer was notified. the approximate failure mileage was 169,066.

The frame of the vehicle is rusted, the rust integrity may result in a steering failure.

Unable to turn wheel without great effort, wheel does not return to straight after turn without driver pulling wheel back to original position. *tr

My 4 runner has extreme frame corrosion due to poor quality. the vehicle is now suffering numerous safety issues as a result. the frame is not repairable and the vehicle is unsafe to drive. it has less than 100,000 miles. the vehicle will not pass state inspection.